Plastic Injection Molding Process

Apr 25, 2024

Leave a message

Preparing the Mold

Polymer resin (pellets) are fed into a auger (screw) which is a large single bottom container. An electric or hydraulic motor is responsible for feeding the pellets inside a heated cylinder through spiral grooves. A gate before the mold cavity restricts flow into the mold and limits backflow. The pressure created by pushing the pellets through the grooves into the gate also creates heat inside the cylinder, helping to melt the polymer and prepare it for injection into the mold.

Injecting Polymer Melt into the Mold

As the auger injects polymer melt into the mold at high pressure (usually 10,000-30,000 psi), it holds it and adds more melt, ensuring that cooling and solidification shrinkage does not leave gaps in the final product. Eventually the gate solidifies and isolates the mold from the injection cylinder.

Cooling the Mold

The mold is usually cooled by air or water. Sometimes small holes are bored into the mold to allow a coolant (e.g. water) to flow through. Cooling the injection mold consumes about 85% of the total process cycle time.

Unloading/Demolding

After solidification, the two halves of the mold that are clamped together close open to allow the part to be removed. The injection molding process can be repeated.
Injection Molding, Plastic Molded Products:
Plastics, quite literally, became the cornerstone of our society. We make so many things from plastic that it is hard to imagine what our lives would be like if it had not been invented. So many of our everyday products are made from plastic that it is easy to understand why plastic injection molding is a huge industry.
About 30% of all plastic products are made using an injection molding process. Of that 30%, a large number of these products are made using custom injection molding techniques. Six steps are involved in the injection molding process after a prototype has been made and approved.
The first step in the injection molding process is the clamping of the mold. This clamping device is one of the three standard parts of an injection molding machine. The mold, the clamping device and the injection device. The clamp is what holds the mold while the molten plastic is injected, and the injection mold is held under pressure while the plastic cools.
Next comes the actual injection of the molten plastic. Plastics usually start this process as pellets, which are put into a large hopper. The pellets are then fed into a cylinder; here they are heated until they become molten plastic that is easily forced into the mold. Once the plastic is in the mold, it is clamped under pressure until it cools.
The next few steps include the dwelling phase, which is to ensure that all of the mold's cavities are filled with molten plastic. After the dwelling phase, the cooling process begins and continues until the plastic becomes solid inside the form. Finally, the mold is opened and the newly formed plastic part is ejected from its mold. Any extra plastic that is outside the part is removed from the mold.
As with any process, there are advantages and disadvantages with plastic injection molding. For most companies, the advantages outweigh the disadvantages; including the ability to maintain high levels of production, the ability to replicate products with high tolerances, and lower labor costs as most of the work is done by machines. Plastic injection molding also has the benefit of reduced scrap costs because the molds are so precise.
However, the disadvantages can be a deal breaker for smaller companies that want to utilize plastic injection molding to produce parts. These disadvantages are that the equipment they require is expensive, therefore, increasing the cost of operation.
Thankfully, for these smaller companies, there are companies that specialize in custom plastic injection molding. They will mock up the mold to exact specifications, run it through the complete process and present the finished piece along with an estimate to complete the job to the customer.